How can I use the laser cutter?

The laser cutter on the 2nd floor of Snell Library is managed by the 3D printing Studio. The 3D studio is open Monday through Friday (hours may vary).

The cost for laser cutting is $5 for up to 2 minutes of operation, then $1 for each additional minute (most cutting jobs take less than 2 minutes). The laser cutter is run on a first come first served basis if you are ready with your material and files on a flash drive. You can submit your files to the studio for review as a .zip to our Order Form, if you wish.

For hours and more information, the 3D Studio's contact info is listed below:

(617) 373-3529